Victron energy 24/30 Bedienungsanleitung PDF herunterladen (Seite 19)

Manual Titan 17

4.1 Permanent boost-charge

In some cases, for example when the battery is almost empty, it is recommended to permanent

boost-charge the battery for 10 hours. Do not permanently boost-charge sealed lead-acid

batteries. Contact your Victron Energy dealer or battery dealer for more information on

charging the battery.

To set the charger into the permanent boost-charge mode:

 Place the DIP switch number 8 “R boost” to the left. In this mode the

battery is being charged to the boost voltage.

 Do not permanent boost-charge the battery for longer than 10 hours

as this can cause long term gas formation in the battery and will

damage the battery.



While a battery is being boost-charged, check the water level of the

battery frequently and if necessary add distilled water to the battery.

4.2 Adjusting the charge voltage

The battery charger has a factory set float and boost voltage. The boost-voltage is always

higher than the float-voltage. These charging voltages are the recommended values from

almost every battery manufacturer. Before adjusting the charge voltage disconnect the

temperature sensor and/or the voltage sense wires.

To change the float-voltage:

 Remove all batteries and other users that are connected to the output

of the battery charger.

 Plug the AC plug into the mains and switch on the charger.

 Place DIP-switches 7 “Eq2” and 6 “Eq1” to the left position, this will

reduce the equalize time to 0 hours. The charger switches into the

float-charge mode.

 Place DIP-switch 4 “fine” to the left position in order to accurately

adjust the output voltage.

 Measure the float-voltage on the charger output by using a precision

voltage meter.

 Adjust the float-voltage by turning the “V float” potentiometer until

the recommended voltage is reached.



Correct the equalize time by moving DIP-switch 7 “Eq2” and 6 “Eq1”.

 Place DIP-switch 4 “fine” to the right position. In this position the

output voltage is less sensitive to influence of temperature.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

Keine Kommentare

Victron energy 24/30 Bedienungsanleitung Seite 19