Victron energy 24/30 Bedienungsanleitung PDF herunterladen (Seite 16)

14 Manual Titan

3.2 Operation

Located on the front of the Titan charger are an on/off switch and three rows of LED’s, as

shown in illustration 5.

The battery charger can be switched on and off with the on/off switch.

The “output voltage” LED’s indicate the output voltage value.

The “output current” LED’s indicate the output current value.

The other LED’s indicates the state of the charger.

The operation sequence:

Switching the charger on with the on/off switch results in the following:

 The “on” led will flash for about 2 seconds. In these first 2 seconds the charger reads all

input signals and calculates the necessary output voltage. After 2 seconds the charger

will switch on and the “on” led illuminates.

 According to the condition of the battery the charger will start in the boost-charge mode

or at float-charge mode. If the battery is not full the “boost” led illuminates and the

charger will start boost-charging the battery.

 A dip switch can be used to set the charger so that it will always start charging in the

boost mode, irrespective of the condition of the battery.

 When the battery voltage has reached the boost voltage the charger will change into the

equalize-charge mode and the “equalize” led illuminates. This mode will last for a pre-

selectable time of 4, 8 or 12 hours.

 After this time the charger will enter the float-charge mode and the “float” led will

illuminate.

llustration 5. Example of the battery charger front panel.

Explosive gasses can occur during charging a lead-acid

battery. Prevent flames and sparks.

Provide adequate ventilation during charging.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Keine Kommentare

Victron energy 24/30 Bedienungsanleitung Seite 16