Victron energy 24/30 Bedienungsanleitung PDF herunterladen (Seite 13)

Manual Titan 11

3. DIRECTIONS FOR USE

3.1 Installation

Find a dry and well-ventilated area to mount the Titan charger and battery. Keep the distance

between the charger and the battery less than 6 meters.

The charger may be wall or floor mounted. Mounting on a wall improves the air circulation

within the charger cabinet and will prolong the lifetime of the battery charger.

The holes for the mains cable, the battery connections, the remote connections and the earth

connection are located at the bottom of the battery charger housing, see illustration 2.

Connecting earth

Connect the earth screw to a real earth-point. Connections to earth have to be according to

applicable safety standards.

 On a ship: Connect the earth screw to the earth plate or to the hull of the ship.



On land: Connect the earth screw to the earth of the mains.

 Mobile applications (a vehicle, a car or a caravan): Connect the earth screw to the frame

of the vehicle.

Connecting the battery

The connections between the Titan charger and the battery are essential for a good operation

of the charger. Therefore the battery connections need tightening well. It is important to use

short and thick battery cables to minimise the voltage losses in the cable. Cable resistance

decreases accordingly as the cables become shorter and thicker. Therefore it is not

recommended to use cables longer than 6 meters. The table below shows the recommended

cable core thickness.

Type core diameter of cables until 1,5m core diameter of cables between 1,5m and 6m

12/50 10 mm

16 mm

24/30 6 mm

10 mm

24/30 110V 6 mm

10 mm

24/50 10 mm

16 mm

48/25 6 mm

10 mm

llustration 2,

ocation of the charger

connection holes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Keine Kommentare

Victron energy 24/30 Bedienungsanleitung Seite 13