Victron energy 24/30 Bedienungsanleitung PDF herunterladen (Seite 8)

3. Installation

WARNING: Qualified personnel only

Instructions

1. Mount wall bracket (for top holding) of the battery charger, make

sure it is level.

2. Install three screws.

3. Open cover by removing four screws, on front bottom cover.

4. Put charger on mounting bracket and mark the Bottom of the

two (M6-D-holes) mounting holes.

5. Install M6 screws.

6. Install AC cord to input terminal strip marked E, N, L, be sure to

use the correct size wire (per ABYC regulations) to use for the

input current marked on the label of charger.

7. Cut DC inlet plugs to cable size, then connect battery cables to

DC lugs marked +DC & -DC. The -DC is used common for all

three batteries. If there are less than three batteries, pick any +DC;

all are capable of full current load. Select appropriate size wire

(per ABYC regulations).

8. Select battery type by pushing the appropriate dipswitch at

bottom left corner of board. Note: This unit is selected for GEL; if

you change battery type DESELECT GEL, (See Figure 1).

9. Replace top cover and reinstall four screws on cover.

10. Apply power and verify Green Led is on (bottom left of PC

board, look through bottom left air vents).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

Victron energy 24/30 Bedienungsanleitung Seite 8